Most first steel pizzas fail before the dough lands. The oven beeps, the air is hot, and the dense slab on the rack is still catching up.

Verdict: Give a quarter-inch steel 45 to 60 minutes to heat up. Put it near the top of the oven, and use the broiler with care. The long preheat matters more than a fancy dough trick.

Heat the steel, not just the oven air

Baking Steel puts its slab on the first or 2nd rack from the top, about 7 inches below the broiler. It sets the oven to 500 to 550F for at least 45 minutes. Its other guide says to allow a full hour for a quarter-inch slab. The oven beep only tells you the air is hot. The steel takes longer. If you have a thermometer that reads surfaces, note the steel’s heat when a pizza turns out well. Aim for that reading next time.

Keep the dough and toppings light

Let cold-fermented dough lose its refrigerator chill before shaping. Press the center by hand, keep the rim intact, and top with restraint. A wet, overloaded pie steams the base and erases the advantage you just preheated for. Dust the peel lightly, build quickly, and give it a small shake before launch. If the pizza does not move now, it will not move at the oven door.

Use the broiler at the right time

Baking Steel says a thin round pizza can cook in about 4 to 6 minutes. Its method uses the broiler for the last 5 to 10 minutes of preheat, then for the first minute or two of the bake. Those steps are optional. Watch the top, and turn the broiler off if it browns too fast. Check the base before you pull the pizza. If the top keeps finishing first, move the steel down a rack next time.

Let the steel heat up again

Each pizza takes heat from the steel. Shut the door between pies and give it time to warm again. If you have a surface thermometer, wait until the center returns to the reading that worked. Baking Steel suggests a second steel when you need to make many pizzas. For a few pies, you can start with one quarter-inch Artisan Steel and watch how well it recovers.

Dry the steel after use

Steel is tough, but moisture still wins. Scrape off baked flour and cheese after the slab cools. A little dish soap is fine, according to Baking Steel; the rule is to dry it completely and wipe on the thinnest film of oil so the next preheat does not fill the kitchen with smoke. Leave the slab in the oven until it is fully cool.

Who should skip a steel

Keep your stone if it already makes pizza you like and you bake only now and then. Dough with honey or sugar may brown too fast on steel. Try less heat, a lower rack, or your stone. If you own an Ooni oven, keep the steel in your home oven. Ooni says its steel is not for Ooni ovens. If you want the soft, charred crust of very hot Neapolitan pizza, a home oven still has a heat limit.

Treat the first bake as a test. Write down the rack, heat reading, and bake time that worked. The next pizza gives you a chance to change just one thing.

Cited sources


More field guides

More Precision Chef guides

All Precision Chef guides